Heater blade is to be used to connect PVC Waterstop
Size of Heater Blades, 2 " ( W) x 30 " ( L) inclusive of 6 " handle for pvc waterstops jointing purposes.

Waterstop heater blade is to be used on the same waterstop profile and width. Water and non oily solvent must be used to clean the waterstop area where jointing is applied. Placed the ready heated up blade in between the two waterstops and pressed them agaisnt the hot blade.

The waterstop will melt but ensure not to the extent of burning or  charring. Removed the heater blade upward quickly and joint molten ends together quickly. Hold the two waterstop together for 20 seconds to allow the molten pvc fuse completely.

While the heater blade is still hot, clean it with the wired brush before the next jointing.